REPORT: Repackaging and Optimization of the Convo Inverter CVFS1 Technical Manual
(or the specific manual-indicated code) and press 'Data/Enter'. This clears custom frequency curves and torque boosts. 2. Physical Repacking for Transit
Terminal Control: Uses external switches connected to terminals convo inverter cvfs1 manual repack
Create a 1-page printable sheet with the 20 most-used parameters (P0.00, P0.01, P0.07, P1.01, P2.00–P2.05 for motor data, P6.00–P6.05 for terminals).
F0.03 (Frequency Setting): Defines how the speed is controlled (e.g., 0 for potentiometer, 3 for 0–10V analog input). REPORT: Repackaging and Optimization of the Convo Inverter
Technician: No worries. I'm here to help. The manual repack is a bit involved, but it's doable. Can you show me the unit and tell me more about what you've done so far?
Overload Capacity: 150% rated current for 1 minute (general purpose). Basic Operation & Commands Operation is primarily set via parameter F0.02: Scenario A: The Drive Trips "E
Step 1 (from repack fault table): E.OC1 = Overcurrent at acceleration.
Step 2 (parameter section): Locate P0.07 (Acceleration time). Default = 5 seconds.
Step 3 (troubleshooting tip box in repack): Increase in increments of 2 seconds. Also check P0.10 (Torque boost) – reduce if >5%.
Outcome: Set P0.07 to 12 seconds. Fault disappears.