((exclusive)) | Egs002+proteus+library+install

The EGS002 is a popular driver board designed for single-phase pure sine wave inverters. Simulating this module in Proteus allows you to test inverter designs, including feedback loops and protection logic, before building physical hardware.

1. Open Proteus ISIS.
2. Right-click the component list on the left sidebar and select "Create New Library" or open an existing user library.
3. Click the "P" (Pick from Libraries) button, then right-click in the device list and select "Create Device".
4. Schematic Symbol: Draw the block representing the EGS002 module (typically a rectangle).
5. Pin Configuration: Add pins corresponding to the EGS002 pinout:

   Cons:

   Observed waveforms:
   – 50 Hz sine wave after LC filter
   – SPWM pulses at H1/L1 pins (20 kHz carrier) egs002+proteus+library+install