Hw 130 Motor Control Shield For Arduino Datasheet __full__ May 2026

The HW-130 Motor Control Shield is a popular, cost-effective expansion board for the Arduino Uno and Mega, based on the L293D quadruple H-bridge chipset. It is designed to drive a variety of inductive loads, including DC motors, stepper motors, and solenoids. Key Technical Specifications

Unused Pins (free for other use):

• D0, D1 (UART – caution if using Serial)
• D2, D3, D4, D13 (LED)
• A0 through A5 (can be used as analog inputs)

4. Power Jumper Configuration

On the board, near the power terminals or the logic chip, you will often see jumper pads or actual jumpers. hw 130 motor control shield for arduino datasheet

6. Schematic & Component Overview

Key onboard components:

• Coil A → M1 and M2
• Coil B → M3 and M4