Iprog Eeprom Adapter Pinout Portable ((better)) May 2026
Note: “iPROG” often refers to the Xgecu T48/T56 programmers or their clones. The common “EEPROM Adapter” for these is typically a SOIC8/SOP8 to DIP8 board (often labeled “iPROG Adapter” or “SOIC8 Test Clip Adapter”).
with 24C, 93C, or 95C series chips, the pinout follows standard electronic conventions: I2C (e.g., 24C02) : Requires connections to SDA and SCL pins. SPI (e.g., 95080/95160) : Requires MOSI, MISO, SCK, and CS pins. MicroWire (e.g., 93C46) : Requires specific DI, DO, SK, and CS connections. Key Usage Guidelines Power Warning : Most iProg+ versions must only be powered via the 5V USB port iprog eeprom adapter pinout portable
: The iProg+ unit is designed to be powered exclusively via a 5V USB port External Power Warning Note: “iPROG” often refers to the Xgecu T48/T56
- VCC: Power supply (usually 3.3V or 5V, depending on the EEPROM chip)
- GND: Ground
- SCL: Clock line (for I2C communication)
- SDA: Data line (for I2C communication)
. Connecting an external 12V supply can damage the hardware. Chip Support: VCC : Power supply (usually 3
- VCC: Power supply (usually 5V or as specified by the adapter)
- GND: Ground
- SCL: Serial Clock line
- SDA: Serial Data line
- WP: Write Protect (optional)
- VPP: Programming voltage (for chips requiring a higher voltage for programming)
1. The SOP8 to DIP8 Adapter (For 93Cxx/24Cxx)
Used for dashboard clusters (e.g., BMW E39, VW Golf 4).